Heat Pump Installation in Austin for properties replacing aging HVAC equipment with single-system heating and cooling

Year-Round Comfort Without Separate Systems


Many Austin homes were built during the 1980s and 1990s with separate furnace and air conditioning units, each approaching the end of its expected lifespan and requiring replacement on different timelines. Gardenhouse Plumbing installs heat pump systems that consolidate heating and cooling into one unit, eliminating the need to maintain and eventually replace two pieces of equipment. You see fewer mechanical components in your home, and the system handles temperature control in both directions without switching between separate furnaces and condensers.


Heat pump installation begins with heating and cooling load calculations based on your property's square footage, insulation quality, window placement, and existing ductwork condition. The system size is matched to actual demand rather than estimated capacity, which prevents short cycling and uneven temperatures. Indoor and outdoor components are connected according to manufacturer torque specifications, refrigerant lines are pressure-tested before charging, and electrical connections are verified for voltage and amperage before the first startup.


Schedule a property evaluation to determine whether your existing ductwork requires modifications before installation.

What Proper Sizing and Installation Require


Equipment sizing involves calculating the thermal envelope of your home—how much heat enters during summer and escapes during winter—and matching the heat pump's capacity to that load. Oversized systems turn on and off repeatedly without completing full heating or cooling cycles, which leaves humidity high and temperatures inconsistent. Undersized systems run continuously without reaching the thermostat setting, particularly during extreme temperatures. Gardenhouse Plumbing performs Manual J load calculations before recommending equipment, ensuring the system operates within its designed performance range rather than at the edges of its capacity.


Once the system is installed and started, you notice air coming from vents matches the thermostat setting consistently, the compressor completes full cycles before shutting down, and indoor humidity levels stabilize during cooling mode. The outdoor unit runs steadily rather than starting and stopping every few minutes, and the system transitions between heating and cooling modes without requiring manual intervention or producing inconsistent airflow.


Installation includes evaluating your existing ductwork for leaks, undersized return paths, and airflow restrictions that reduce system efficiency regardless of the equipment installed. Ducts are sealed where accessible, and return air pathways are enlarged if the original installation used undersized grilles. Thermostat wiring is upgraded to support multi-stage or variable-speed operation when the new system includes those features.

Homeowners in Austin often ask about heat pump operation and installation requirements before committing to the transition from traditional HVAC systems. These questions address the practical aspects of the work itself and what changes once the system is running.

Common Questions About This Service

  • How is the heat pump sized for my home?

    Load calculations account for your home's insulation, window area, ceiling height, and air infiltration rate, then match those thermal characteristics to a system with appropriate heating and cooling capacity measured in BTUs and tonnage.

  • What happens to my existing ductwork during installation?

    Ducts are inspected for leaks, crushed sections, and disconnected joints, then sealed and repaired where necessary to support proper airflow from the new system.

  • How does the installer verify the system is working correctly after installation?

    The system is run through complete heating and cooling cycles while measuring refrigerant pressures, airflow volume, temperature differential across coils, and thermostat communication to confirm operation matches design specifications.

  • Can a heat pump be installed in a home that currently has a gas furnace?

    The indoor furnace is removed and replaced with an air handler that includes the evaporator coil and blower, using the existing ductwork and modifying electrical and refrigerant connections as needed.

  • What do you notice once the heat pump is operating?

    Airflow becomes consistent across all vents, temperature swings narrow as the system modulates output rather than cycling fully on and off, and the single outdoor unit handles both summer cooling and winter heating without requiring separate equipment.

Gardenhouse Plumbing also installs heat pumps in Kyle, Buda, Round Rock, Cedar Park, Pflugerville, Leander, and Georgetown. Request an on-site consultation to review your current HVAC equipment and discuss heat pump options matched to your home's heating and cooling requirements.